Model Maker easily does cut and fill volume calculations between surfaces.
The results are reported as totals, volume by depths below the top surface and also volumes in contour groups.
The groups always had a 0 index. Meaning if the contour group is 8m thick then the report will be in intervals of 0,8,16,24......96,104....
But it was not possible to include 101,109,117 etc in the report if needed.
Now with the user defined Index elevation the user can set the contour and the report will arrange the results to include that value. eg, 93,101,109....
As an example this option could be used when doing a project where 101 is a bench mark and the volume need to be reported in layers of 8m thick in relation to the 101 bench mark.
See video : Contour index
Comments
Post a Comment